Setup and Climate Control

Greenhouse Shade Cloth: When to Use It and Which Percentage to Pick

Learn when to hang greenhouse shade cloth, which density to choose for vegetables, herbs and ornamentals, and whether to fit it inside or outside.

On this page
  1. Short answer
  2. What the percentage means
  3. When to put it up
  4. When to take it down
  5. Percentages by crop type
  6. Inside or outside?
  7. Knitted or woven, and other types
  8. Installation tips
  9. Signs you picked the wrong density
  10. Other shading options

Short answer

Use shade cloth when strong sun is pushing your greenhouse above the temperature your plants tolerate, or scorching leaves, even after you have opened vents. Many vegetable growers use a density in the 30 to 50 percent range, with 50 to 60 percent common overall and higher densities used for very hot climates or light-sensitive plants. Start lighter than you think you need, since too much shade slows growth.

What the percentage means

Shade cloth is rated by the share of light it blocks. A 50 percent cloth lets about half the light through, and a 90 percent cloth lets only about a tenth through. Because heat enters with sunlight, blocking light also reduces heat, but also reduces the light available for photosynthesis. Labels vary between makers, so check what the percentage refers to.

When to put it up

  • When temperatures stay too high despite ventilation. Shade is usually one part of a package with vents and airflow (see how to cool a greenhouse in summer without air conditioning).
  • When leaves show scorch, pale or bleached patches, or wilting at midday.
  • In late spring, summer and early autumn in many regions, when the sun is strong.
  • For seedlings and young transplants, which can burn more easily.
  • For plants that prefer lower light, such as many ferns, foliage plants and some orchids.

When to take it down

Remove it, or roll it back, when the sun weakens in autumn and when you have a run of cloudy weather. In winter, light is usually the limiting factor, so keep glazing clean and unshaded. Rolling cloth that you can pull across on bright days, and roll up on dull days, gives you flexibility.

Percentages by crop type

These are rough guides. Your climate and the plants’ stage matter as much as the numbers.

What you grow Typical starting range
Fruiting vegetables (tomatoes, peppers, cucumbers) Often about 30 to 50 percent, only in hot spells
Leafy greens and cool-season crops Around 30 to 50 percent in warm weather
Seedlings and cuttings Light to moderate, often 30 to 50 percent
Herbs Mediterranean herbs often need little or none, while cool-season herbs may like a light cloth (see do herbs grow well in greenhouses)
Shade-loving foliage plants and some orchids Higher densities, possibly 50 to 70 percent or more
Succulents and sun-lovers Little or none, or light shade in extreme heat

In hotter southern regions growers often go up to 70 or 80 percent, and growers in more northerly areas may also use higher densities for light-sensitive plants. If you aren’t sure, begin at 30 to 40 percent, and add more if needed.

Inside or outside?

  • Outside: blocks heat before it enters the greenhouse, so it is generally more effective at cooling. It must resist wind and be well secured.
  • Inside: easier to install and adjust, and protected from the weather, but the sun’s heat has already passed through the glazing.

For small greenhouses, many gardeners drape cloth over the outside on the sunniest side, or clip a section inside above the most exposed plants, and roll it up when not needed.

Knitted or woven, and other types

Knitted shade cloth is widely recommended for greenhouses. It comes in a range of densities and resists fraying and tearing better than woven cloth, which can unravel when cut. Some cloths are reflective or aluminized, which reflects some sunlight and heat. Colors have different effects on light quality, and black cloth absorbs more heat than reflective or white types, so pick based on your goal.

Installation tips

  • Measure before you buy, and leave extra for overhang.
  • Use clips, grommets, rope or battens designed for greenhouse use so the cloth doesn’t flap or tear.
  • Leave a gap between cloth and glazing if you can, so air can flow.
  • Don’t block vents.
  • Make it easy to remove ahead of storms.
  • Wash and store it dry at the end of the season.

Signs you picked the wrong density

  • Too little shade: leaf scorch, wilting, soil drying very fast, and the greenhouse still overheating.
  • Too much shade: leggy, pale or slow growth, fewer flowers and fruit, and plants stretching toward gaps.

Adjust by swapping to a lighter cloth, or by shading only part of the roof or the hottest hours.

Other shading options

Shading paint, external blinds, internal blinds, taller plants, and siting decisions can also help. Shading works best alongside ventilation, watering practices and monitoring. For general planning, see setting up a small greenhouse, and don’t forget to wash off shading at the end of the season as part of the maintenance checklist.

The complete guide to setup and climate control

Setting Up and Designing a Small Greenhouse
Read the guide

Keep exploring

Guides from other topics

All topics →