Short answer
The right heater size depends on how much warmer you want the inside than the coldest outside night, how much surface your greenhouse has, and how well it is insulated. A simple estimate is:
Heat needed (BTU per hour) ≈ surface area (sq ft) × temperature rise (°F) ÷ R-value
Treat the result as a starting point, add a safety margin, and compare it with the manufacturer’s guidance. A properly sized, thermostat-controlled heater is better than an oversized unit running flat out.
What decides the size
- Your target temperature. Do you only want to keep plants above freezing, or hold a warm growing temperature? Frost protection takes far less heat than growing tropical plants through winter. Extension advice suggests that if your goal is mostly an early start to the season, you may not need much supplemental heat at all, since you are basically trying to keep crops from freezing.
- Your coldest expected night. Use the typical minimum temperature for your area, not an average.
- Surface area of the covering. Heat escapes through the roof, walls and ends. Add up the area of all exposed surfaces, not just the floor.
- Insulation (R-value). Higher R-values mean less heat loss. Extension sources give rough values of about 1.25 to 1.42 for double-layer 6 mil poly, about 0.85 for single-layer film, and about 1.7 for twin-wall polycarbonate. Where a greenhouse mixes materials, an average gives a rough figure. These are approximations, and actual performance varies.
Worked example
Say your greenhouse has about 300 square feet of covering. You want to keep the inside at 45°F when the outside gets down to 10°F, a rise of 35°F. Your covering averages an R-value of about 1.5.
- 300 × 35 ÷ 1.5 = 7,000 BTU per hour
This is only an illustration. Your numbers will differ, so measure your own surfaces and use your own targets. Many people add a margin, such as 10 to 25 percent, to cover wind, drafts and gaps. Heater makers and greenhouse suppliers often have online calculators, which can help check your arithmetic.
Converting watts and BTU
For electric heaters, one watt is about 3.4 BTU per hour. So a 1,500-watt heater delivers roughly 5,100 BTU per hour. That is why a 1,500-watt unit is a common choice for small hobby greenhouses, and why the same unit would be far too small for the example above.
Insulate first
Cutting heat loss is usually cheaper than buying a bigger heater. Options include horticultural bubble wrap, extra layers of film, insulating end walls, sealing gaps and weather-stripping doors and vents. Thermal mass, like water barrels, helps smooth swings. See how to keep a small greenhouse warm at night. Better insulation raises the R-value in the formula and reduces the heater size you need.
Electric or fuel-burning?
- Electric with thermostat: clean, controllable and usually the simplest for small greenhouses. It needs a safe, protected power supply.
- Propane, kerosene or other unvented combustion heaters: they release moisture and can give off fumes, which raises humidity and stresses plants, and they can create carbon monoxide risks if poorly ventilated. See how to control humidity in a greenhouse.
- Vented gas or oil heaters: common in larger greenhouses, they need proper flues and professional installation and servicing.
Thermostat, placement and safety
- Use a thermostat so the heater only runs when needed.
- Put the heater where air can circulate, away from plants, plastic and anything flammable. A small fan can help spread heat.
- Use equipment rated for damp or outdoor conditions, on a protected circuit. Have permanent wiring installed by a qualified electrician.
- Keep fuel-burning units properly vented and follow the manufacturer’s instructions.
- Consider a temperature alarm so you know if the heater fails.
- Keep a backup plan, such as covers and a few thermal mass containers.
When you don’t need a big heater
If your aim is only to avoid hard frosts, hardy crops and good insulation may be enough with a small thermostat heater. If you grow heat-loving crops through the cold season, expect a larger heater, bigger bills, and a need for better insulation. For general planning, see setting up a small greenhouse, and keep heaters and thermostats in good order using the maintenance checklist.