How greenhouses lose heat
A greenhouse traps solar heat during the day, but at night most of it escapes. Heat leaves in three main ways: through the glazing (the biggest surface), through gaps and leaks, and through the ground and base. A good insulation plan tackles all three, starting with the cheapest and easiest.
Insulation also reduces how hard any heater has to work, which usually saves money if you heat at all. To size a heater, see what size heater you need for a greenhouse. Keep in mind that insulating a greenhouse is always a trade-off with light, so the aim is to reduce heat loss without blocking too much sun.
Cheapest ideas first
Seal gaps and drafts
Check around doors, vents, glazing panels and the base. Draught-proofing strip, weatherstripping, sealing tape and sealant can all help. Replace cracked or slipped panes. This is often the best value, because air leaks can lose a surprising amount of heat. For the door, see how to build a greenhouse door that seals well.
Bubble wrap
Horticultural bubble wrap (the large-bubble, UV-stabilized type) is a popular, inexpensive option. It is stuck to the inside of the glazing, usually with water or clips, and traps a layer of still air. It lets through a good amount of light, but reduces it somewhat. Garden-grade wrap lasts several winters, whereas packaging bubble wrap tends to degrade quickly. Leave the roof vents and any ventilation areas clear.
Upgrading the glazing
If you are building or re-glazing, the glazing itself is the biggest lever:
- Twin-wall polycarbonate insulates better than a single pane of glass, thanks to the air trapped in the channels.
- Double-layer polyethylene film with an air gap between the layers insulates better than one layer, and is a common method on hoop houses.
- Double-glazed units are more expensive, but very effective.
See greenhouse glazing: glass, polycarbonate and FRP for the full comparison.
Insulating the base and walls
- Perimeter insulation: Rigid foam boards on the inside of a low base wall or foundation reduce heat loss through the ground edge. Make sure they are protected from UV and rodents.
- Solid walls: If part of the greenhouse has a solid wall, such as a lean-to against a house or a low brick wall, insulating it makes a real difference. A north-facing solid wall can be insulated, and lined with a reflective surface to bounce light back towards plants.
- What can you use for greenhouse walls? Glass, polycarbonate, FRP or film for glazed areas, and insulated panels or masonry with insulation for solid sections.
For options on the foundation itself, see greenhouse base and foundation options.
Thermal curtains and screens
Thermal screens are retractable fabric layers drawn across the roof or walls at night. They trap an insulating layer of air close to the plants and are common in commercial greenhouses. Home-scale options include:
- Horticultural fleece or frost cloth draped over plants or benches on cold nights.
- Reflective or woven thermal fabric hung from wires inside the roof.
Fleece is cheap and useful as a flexible, on-demand layer for the nights that really matter.
Thermal mass
Dark-colored water barrels, stone or bricks absorb heat during the day and release it slowly at night. This evens out temperature swings without any fuel. It will not make a greenhouse frost-proof alone, but it can give a few degrees’ buffer. Place the mass where it gets direct sun and doesn’t take up your growing space. More low-tech ideas are in how to heat a greenhouse in winter without electricity.
How do Amish keep greenhouses warm in winter?
Practices vary widely between communities, but reports commonly describe a mix of passive and low-tech approaches: south-facing sites, double-layer film, thermal mass, and simple heating by wood or gas where heat is needed. Unless you have an experienced local source, treat those details as general ideas, and check what works in your climate. For passive solar design in detail, see building a year-round solar greenhouse.
Don’t forget ventilation and safety
Insulation can make a greenhouse airtight, and that creates problems:
- Humidity and condensation build up, encouraging mildew and disease. Keep some ventilation and air movement. See greenhouse roof vents and ventilation and how to control humidity in a greenhouse.
- Fuel heaters such as propane, kerosene or wood burn oxygen and release combustion gases, so they need an appropriate flue or adequate fresh air. Always follow the heater’s instructions, and consider a carbon monoxide alarm.
- Overheating on sunny winter days can be a risk, so vents must still open when you need them.
Insulation covers what a heater can’t do for you, and it does that best when the structure is sound. Before spending money on extras, make sure the basics, such as glazing and gaps, are in good shape. See greenhouse structure: parts and components explained for the overall layout.