Greenhouse Types

Sun Pit Greenhouses: Design and Build

How a sun pit (walipini) greenhouse works, where it suits, its drainage and safety risks, and the main design and build steps before you dig.

On this page
  1. What a sun pit greenhouse is
  2. How it works
  3. Advantages
  4. Drawbacks and risks
  5. Design basics
  6. Building steps in outline
  7. Safety and permits
  8. FAQ

What a sun pit greenhouse is

A sun pit greenhouse is built partly below ground level, with a sloped glazed or plastic roof that lets in sunlight. It is also called a walipini, a name taken from the Aymara language that is often translated as “place of warmth”, or simply an underground or in-ground greenhouse. The design was developed for cold, high-altitude regions of South America and is now used by growers elsewhere who want to cut heating needs.

How it works

Soil a little below the surface stays close to a steady temperature through the year, changing much more slowly than the air. By setting the growing area into the ground, the earth acts as a buffer against cold nights.

A typical design works like this:

  • The long side of the building faces the winter sun: south in the northern hemisphere, north in the southern hemisphere.
  • A tall back wall and a lower front wall support a sloped roof angled toward the sun.
  • Sunlight enters through the roof and warms the soil, walls and anything with thermal mass inside, such as water barrels or stone.
  • At night, the stored heat is released slowly back into the space.

In very cold climates you may still need a back-up heat source during cold snaps.

Advantages

  • Lower heating need. The earth cover reduces heat loss compared with an above-ground structure of the same size.
  • Wind protection. Most of the building sits below the wind.
  • Low-cost materials. Many designs use local earth, stone or earth-bricks for walls and plastic sheeting for the roof, though costs vary widely with site and labour.
  • Stable conditions. Daily temperature swings tend to be gentler than in a standard greenhouse.

Drawbacks and risks

  • Water table and drainage. Digging into ground that floods or has a high water table is a serious problem. Check drainage before you commit, and plan for water to run away from the pit.
  • Less light in winter. The below-ground position and the angle of the roof can reduce light, especially in the shortest days. Some growers add supplemental lighting.
  • Humidity and condensation. Enclosed earth-sheltered spaces can be damp, so ventilation and fungal disease control matter.
  • Digging effort. Excavating a large pit is heavy work and may need machinery. Digging deep trenches has its own hazards, see below.
  • Access. Steps, ramps and carrying soil or tools down into the pit take planning.
  • Gas safety. Enclosed, below-ground spaces can accumulate radon, carbon dioxide or other gases. Good ventilation is essential, and some builders also use gas monitors.

Design basics

  • Orientation. Align the long axis east-west so the main roof faces the winter sun.
  • Depth. Designs typically go several feet down. Deeper is not always better because it reduces light and increases flooding and safety risks.
  • Walls. Use materials that resist moisture and hold heat, such as stone, concrete block or properly stabilised earth. Waterproof the walls where they meet soil.
  • Roof. A sloped roof of polycarbonate or a double layer of plastic film is common. A double layer traps an insulating air gap.
  • Thermal mass. Dark water barrels, stone or masonry inside can store heat.
  • Ventilation. Include vents at the top and a way to bring in fresh air. Summer overheating is common if you do not.
  • Drainage. Put a drainage layer or French drain around and under the floor, and a surface channel above the pit so rain does not pour in.

Building steps in outline

  1. Check local rules, utilities and soil conditions.
  2. Mark the footprint and excavate to your planned depth, shoring walls where soil could collapse.
  3. Build or stabilise the walls and install drainage.
  4. Set the roof frame at the correct angle and attach the glazing.
  5. Add doors, vents and entry steps.
  6. Add beds, benches and thermal mass, then test temperatures over a few weeks before relying on it.

Safety and permits

Do not dig deep trenches or pits without understanding the risk of collapse; unsupported soil walls can be dangerous. Call utility locating services before digging and check local planning or building rules, since below-ground structures are sometimes treated differently from garden sheds.

FAQ

Should a greenhouse be in full sun or shade?

Most greenhouses do best in a spot with plenty of sun, ideally away from large trees or buildings that shade them in winter. A pit design depends even more on direct sunlight. In hot climates, shade cloth can help reduce summer heat.

How do people heat greenhouses in winter without much fuel?

Common low-fuel approaches include passive solar design, thermal mass such as water barrels, insulation on north walls, earth-sheltering and, for some growers, wood stoves or compost heat. How well each works depends on climate and size.

Is polycarbonate a good roof for a pit greenhouse?

It is often used because it insulates better than single glass or film and is fairly durable, but it has downsides of its own. See the disadvantages of polycarbonate greenhouses.

For a wider comparison of designs, see the greenhouse types overview, or read about brick and cob greenhouses, which also use mass to hold heat.

The complete guide to greenhouse types

Types of Greenhouses by Shape and Style
Read the guide

Keep exploring

Guides from other topics

All topics →