Two ways to use masonry in a greenhouse
Most garden greenhouses have light frames and glazed walls. Brick and cob greenhouses use heavy walls instead, usually on at least one side. The idea is simple: dense materials absorb heat when the sun is out and release it slowly when the air cools, which can soften night-time temperature drops.
Both approaches generally keep glazing on the sunny side, with the solid wall on the north side (in the northern hemisphere) or the south side (in the southern hemisphere).
Brick-built greenhouses
There are several common ways to use brick:
- Dwarf walls. A low brick wall around the base, with a glazed frame above. This is the traditional Victorian approach. It protects the base from knocks, adds some insulation and gives a firm fixing for the frame.
- Full brick back wall. A greenhouse with a brick or block rear wall and glazed front and roof. This is similar to a lean-to built against an existing wall.
- Fully brick structures. Walls of brick or block with large windows and a glazed roof. These are closer to a small building than a typical greenhouse and may be treated as one by building rules.
A south-facing garden wall (north-hemisphere gardens) can be a good starting point, since it already stores heat. If you build against it, check its condition and make sure moisture from the greenhouse will not damage it.
Cob greenhouses
Cob is a traditional building material made from clay-rich subsoil, sand and straw, mixed wet and shaped by hand. It is used in many parts of the world for walls, ovens and houses. In a greenhouse, a cob wall can serve as a heat store and can be sculpted into curves, niches or built-in benches.
Cob does need careful treatment:
- It must sit on a stone or masonry base so it does not wick moisture from the ground.
- It needs a wide roof overhang or other protection from rain, since long-term wetting weakens it.
- Interior humidity is high in a greenhouse, so surface finishes and ventilation matter.
- It is slow to build, since layers need time to dry.
Beginners often benefit from a workshop or an experienced builder, since good cob depends on the right soil mix.
Benefits of thermal mass
- Slower temperature swings through day and night.
- A more stable environment for tender plants, in mild climates especially.
- Durable walls with a long life if kept dry.
- Attractive, natural appearance.
Thermal mass is not a heater. In a hard freeze, a brick or cob wall will not keep a greenhouse above freezing without additional help, and it can take a while to warm up after a cold spell.
Drawbacks
- Weight and foundations. Brick and cob are heavy and need proper foundations, which increases cost and effort.
- Cost and time. Masonry is usually more expensive and slower than a kit greenhouse, and cob in particular is labour-intensive.
- Less light. Solid walls cut the glazed area compared with an all-glass house.
- Moisture. Damp in the wall base or around the roof joint can damage masonry over time, especially in freeze-thaw climates.
- Permanence. You cannot easily move it.
Design tips
- Put glazing on the side facing the sun and the solid wall on the opposite side.
- Add vents at both high and low levels, since solid walls limit natural airflow.
- Consider painting inner wall surfaces light to bounce light onto plants, or leaving dark surfaces if you want more heat absorption. Each has a different effect, so decide based on climate.
- Use a damp-proof course between the ground and masonry or cob.
- Plan drainage around the base.
- If you want more heat storage, add water barrels or stone.
For another way to use the ground and walls to hold heat, see sun pit greenhouses. If you want a combined living and growing building, read about the bioshelter. For a standard timber or aluminium alternative, see the gable greenhouse.
Permits and legality
Brick and cob structures are more likely than light kits to need building approval, because they are permanent and heavy. Legality of cob buildings varies by country and region. In some places they are fully allowed and covered by building codes, in others they need special approval, and some areas have little experience with them. Contact your local planning or building office before starting.