What a PVC dome greenhouse is
A PVC dome greenhouse uses lengths of plastic pipe to make a rounded frame, covered with greenhouse film. The pipe is cheap, light and easy to cut with a hand saw, which is why PVC is one of the most common materials for a first greenhouse. For the name of the shape itself, see what is a domed greenhouse called. For other shapes, see types of greenhouses by shape and style.
Pros and limits
Advantages
- Low material cost and no special tools.
- Light enough to move or take down for winter.
- Rounded shape sheds rain and a little snow.
Limits
- PVC can become brittle with long sun exposure and in cold weather, and a frame may sag or crack over a few seasons. Using pipe rated for outdoor use, or painting it, can help.
- It is not very strong in high wind or under heavy snow, so anchor it well and clear snow promptly.
- A single layer of film has little insulation.
If you expect harsh weather, a stiffer frame such as a cattle panel greenhouse may serve better.
Two approaches: hoop dome vs geodesic
Hoop-style dome. Pipes are bent in arches and fixed to a base. It is simpler and gives a half-barrel or dome-like profile. Most DIY PVC greenhouses are this type.
Geodesic dome. Many short struts join at hubs to form triangles. It gives a true dome and is strong for its weight, but the struts must be cut to precise lengths and joined with hubs or connectors. PVC does not bend, so a geodesic frame needs accurate planning. Use a published strut-length chart for your chosen size and frequency rather than improvising.
The steps below cover the hoop style, which is better for a first build.
Materials
For a small structure of roughly 8 by 10 feet (adjust to suit):
- 3/4-inch or 1-inch PVC pipe for the hoops. A thicker pipe or a higher schedule gives a stiffer frame. Check the local hardware store’s range.
- PVC pipe or lumber for a ridge pole and base rails
- Tees and elbows for joining
- Rebar stakes or pipe sleeves to hold hoop ends
- Greenhouse film, UV-stabilized
- Clips or clamps to hold the film, or wood battens
- Lumber for a door frame
- Duct tape or pipe insulation to protect the film at contact points
Build steps (hoop-style dome)
- Mark and level the site. Mark the footprint and drive rebar stakes about 2 feet apart along each long side, leaving about 18 inches above ground. Keep each pair directly opposite each other.
- Fit the hoops. Slide one end of a PVC length over a stake on one side. Bend it over and fit the other end onto the matching stake. Repeat down the length.
- Add a ridge pole. Join the hoops along the top with a pipe, using tees or ties. Add one or two more rails along the sides for stiffness.
- Frame the ends. Build end walls from lumber, with a door on one end. See how to build a greenhouse door that seals well.
- Cover the frame. Drape film over the structure on a calm day, pull it tight and clip it. Wrap tape or foam around joints and screws where film touches.
- Secure the edges. Bury the bottom edge, weigh it with boards or sandbags, or attach it to a base rail.
Covering and anchoring
Greenhouse-grade polyethylene film is designed to resist sun and generally lasts some years. Ordinary construction plastic degrades quickly. Anchor hoops with deep stakes and fix the base to the ground, because wind lifts light frames easily. See how to anchor a greenhouse against wind.
Lifespan and care
PVC frames often last a few seasons, depending on your climate and sun exposure. Check joints each spring, replace any pipe that has cracked, and replace the film when it yellows or tears. If you plan to keep the structure for many years, consider a more durable frame. For how long different greenhouses last, see what is the life expectancy of a greenhouse. Our overview of backyard greenhouse building compares the options.