DIY Greenhouse Building

Glass Greenhouse Plans and Build Guide

A practical guide to glass greenhouse plans: glass types and sizes, frame and base needs, installing panes, safety, cost and upkeep for a DIY build.

On this page
  1. Why choose glass
  2. Glass types
  3. Sizes
  4. Frame and base requirements
  5. Plan: a small glass greenhouse
  6. Installing panels
  7. Safety
  8. Cost, permits and upkeep

Why choose glass

Glass is the traditional greenhouse glazing. It is clear, resists scratching and yellowing, and can last for decades if the frame stays sound. Its drawbacks are weight, breakage, a higher cost than film, and weaker insulation than multiwall polycarbonate unless you use double glazing. If you are still deciding, compare it with the options in how to build a greenhouse with polycarbonate panels. For a side-by-side of glazing materials, see greenhouse glazing: glass, polycarbonate and FRP.

Glass types

  • Horticultural glass is a thin, clear glass sold for greenhouses, often 3 mm thick. It is lightweight for glass but breaks into sharp shards.
  • Tempered (toughened) glass is stronger and, when it breaks, crumbles into small pieces rather than large shards. It is safer, especially for roofs and areas near people. Tempered panes must be cut to size before tempering, so you need accurate measurements before ordering.
  • Laminated glass holds together when broken but costs more.
  • Double-pane units insulate better but are heavy and require a stronger frame.
  • Reclaimed windows and doors are cheap, but check for lead paint on older ones and expect mismatched sizes. Our cheap greenhouse guide discusses salvaged materials.

Many builders prefer tempered or laminated glass overhead and standard glass on walls, but check local safety rules and what your supplier recommends.

Sizes

Greenhouse glass is available in several standard sizes, and these differ by country and supplier. Kit and aluminum greenhouse systems are designed around particular pane sizes. The best approach is to choose your glass first and then size your frame around it. If you design the frame first, you may have to order custom panes, which costs more. Check the exact dimensions with your supplier.

Frame and base requirements

Glass is heavy, so the frame must be stiff and square. Wood, aluminum and steel can all work (compare them in aluminum, wood or steel greenhouse frames). Key points:

  • Square, level base. Panes crack when a frame racks or twists.
  • Rafters or glazing bars spaced to suit the glass, with a small gap around each pane for expansion.
  • A proper foundation. A concrete footing, a blockwork dwarf wall or a sturdy timber base is common. See greenhouse base and foundation options.
  • Brace the frame against wind loads.

A wood frame is the usual DIY approach. See the wood-frame greenhouse guide for the base and framing steps, adapting the rafter spacing to your glass.

Plan: a small glass greenhouse

A modest lean-to or freestanding design works well for a first glass build. A typical layout is a rectangular base with low side walls (solid timber or block) topped with vertical glazing, and a gable roof with glass or polycarbonate. Using solid lower walls reduces the glass area and the breakage risk from mowers and footballs. A lean-to also reduces the number of panes. Add a door and at least one roof vent.

Installing panels

  1. Dry fit every pane before fixing it.
  2. Bed the glass on glazing tape, putty or a rubber gasket, depending on the system, so glass never touches the frame directly.
  3. Fix with glazing clips, bars or beads. Tighten gently, leaving a small movement allowance.
  4. Start at the bottom and work up so each pane laps correctly on the roof, or follow your system’s instructions.
  5. Seal gaps around panes with an appropriate sealant, then check the door and vents.

Wear cut-resistant gloves and eye protection, carry panes upright with a helper, and avoid working on the roof glass directly, using a board or ladder arrangement that spreads your weight. For glazing methods for other materials too, see how to glaze a greenhouse.

Safety

Glass can cause serious injury. Use tempered or laminated glass where people or children are nearby, and for any overhead panes where possible. Keep spare panes stored upright and padded. Clear broken glass promptly, including shards in the soil.

Cost, permits and upkeep

Glass and a strong frame cost more than a film-covered structure, and prices vary by region. Larger glass structures are more likely to need permits, so see do I need a permit for a backyard greenhouse. Upkeep includes washing glass occasionally, checking seals and replacing cracked panes quickly. For the broader picture, see our guide to building a backyard greenhouse.

The complete guide to diy greenhouse building

How to Build a Backyard Greenhouse
Read the guide

Keep exploring

Guides from other topics

All topics →